When you complete your quilt, you will want to consider binding options.  Some quilts are bound by folding the quilt backing around to the front. The backing is first trimmed to an even distance from the quilt top all the way around. The outer edge is folded over about a half-inch and pressed in place. Pin this pressed edge to the front of the quilt, at least a quarter-inch inside the edge of the quilt top. The folded edge is then hand or machine stitched to the quilt top.

 

At the corners, fold the edge in at a 45 degree angle and then miter the edges together at the corner.

Fold the corner again until it is the same width as the sides.

When you fold the two side pieces towards the quilt top, they should form a mitered edge. Adjust until the two edges meet in the center of the corner and pin in place. Stitch the mitered corner.

Sometimes you may wish to use a binding of a different color or from a different fabric. Commercial seam binding is a readily available option. The problem with commercial seam binding is that it comes in solid colors. There are a variety of colors available, but many times the shade of your desired color is not compatible with your quilt fabrics.

To circumvent this color and fabric print problem, you may wish to make your own seam binding. You can choose a fabric from the quilt top or another coordinating fabric.

Make sure that the fabric has been washed and pressed before you begin. Unwashed cottons will very likely shrink and disfigure your quilt.

Place the fabric on your cutting mat. You can cut your strips on the bias and use a bias tape maker to form perfect folds for attaching the binding to your quilt. Cutting mats such as this one have a bias line marked on the grid.

Some quilters prefer to cut the strips on the straight grain of the fabric because it does not stretch. Binding cut on the bias stretches and folds easily, but can pucker if too much stretch occurs along the stitched edge.

Cut the strips to the width of your bias tape maker. This tape maker measures 2-3/4 inches. Strips can be cut at 2-1/2 or 2-3/4 inches. There are many bias tape makers available at sewing and quilting stores. They come in a variety of widths. Check your bias tape maker to make sure you are cutting the right width for your strips. To increase the length of your strips, cut the fabric ends at 45-degree angles. Place the 45-degree cut edges together with right sides together. The strips should form an L-shape. Stitch together on wrong side of fabric. Press strip, pressing seams open. Continue until you have long enough binding strip for the entire quilt.

Feed the fabric strips through the bias tape maker and press the folds as they come out the flat end.

Fold the pressed strips so that the folded edges match up. Press the folded edges together making a crease in the center.

When binding strip is complete, loop it in long folds or roll it up to keep the creases from flattening out before you pin them to the quilt edges.

Pin binding strip to the quilt edge on the back. Miter corners. Stitch binding strip to back of quilt by machine or by hand.

Turn quilt to front and pin binding in place. Edge of binding should overlap edge of quilt top by about 1/4-inch. Make sure your binding strip is folded evenly and does not have puckers or stretched areas. Hand or machine stitch front of quilt and binding together, mitering corners.